Registered firefighters 1, 2, and 3 equipment contractors
Registered electrical contractor, registered plumbing contractor
Registered minor works contractor (Levels 2 and 3)
Competent persons for mandatory window inspection programs

Print this page

AMPS-24E Power Supply

  • NOTIFIER’s AMPS-24/E is an addressable power supply and battery charger with up to three 24 VDC outputs. It operates in either FlashScan® or CLIP (Classic Loop Interface Protocol) mode with the NFS-3030/NFS2-3030 Fire Alarm Control Panel (FACP). It can also be used as the primary power supply for the NCA-2 Network Control Annunciator.



• Addressable by NFS-3030/NFS2-3030 FACP.
• Selectable charging current charges 7 AH to 200 AH batteries.
• Isolated Signaling Line Circuit (SLC) interface.
• Trouble bus input for use with normally-open dry contacts or open-collector circuit.
• USB Type B connector for programming installation parameters.
• Brownout detection.
• Battery/battery charger supervision.
• Secondary Power Auxiliary Outputs: 24V @ 0.5A and 5V @ 0.15A.
• AC loss detection and AC loss delay reporting.
• Mounts in a CAB-4 Series enclosure, EQ Cabinet Seriesenclosure, BB-25, BB-100, or BB-200 Battery Backbox.

 

Download

AMPS-24E Power Supply

 

 

 

 

  • AMPS24E: 220-240 VAC 50/60 Hz input, 2.5 A maximum.
  • MAIN 24V Output - filtered power-limited power. Refer to table for configuration/current information.
  • AUX 24V - provides filtered power-limited power for additional components. Refer to table above for configuration/ current information.
  •  Secondary power (battery) charging circuit: Current-limited, sealed lead-acid battery charger which will charge 7 to 200 AH batteries. Selectable charging current: 1.0 A, 2.0 A or 5.0 A.
  • Secondary power auxiliary outputs.
  • Wire sizes: 10 AWG (5.26 mm²) to 22 AWG (0.326 mm²).
  •  Battery fuse (F2): 15 A, fast-acting.
  • Shipping Weight: 4.25 lb

 

• UL: S635
• ULC: CS118
• City of Chicago
• City of Denver
• MEA: 345-02-E
• CSFM: 7165-0028:224
• FM: Approved
• FDNY: #6026